Introduction
The Scribe candle clock is the second scribe holding a pen out of three scribes that appear in the book. The scribe rotates continuously and passes fifteen degrees every hour, so one degree (one marking) is approximately four minutes. We already met a scribe holding a pen in the elephant water clock (in Hebrew), and soon I hope to write on the beaker water clock that has a different mechanism, but a very similar scribe. The scribe and his pen are used as a hand in a clock. It reminded me “modern” analog clocks and made me go back and examine the development of concepts such as minutes and seconds and the development of the clock dial.
The candle clock of the scribe ” Book of Knowledge of Ingenious Mechanical Devices” Topkapi manuscript, 1206.
How does it work?
Al-Jazari opens this chapter:
“I came upon a clock made by Yunus al-Asturlabi which had the appearance of the clock I described in the first chapter[ meaning the candle clock of the sword men]. A cross-beam which had a hole in its center for the wick replaced the cap which I used to hold the candle down, and I discovered that the wax flowed into the interior of the sheath and over the instruments inside the sheath. .. This gave much trouble; for this reason the design was useless. “
We do not know who Yunus al-Asturlabi was. Eilhard Wiedemann, a German physicist, one of the first researchers of science in Islam, who did much to bring the work of the al-Jazari to the west, suggested the astronomer and mathematician Ibn Yunus. Probably we will never know for sure. Correct identification or not, it is quite interesting because we have no evidence of any sophisticated candle clocks before al-Jazari’s.
The technical explanation, as always, will be colored in blue, so anyone who is not interested in pulleys or balancing weight can skip those bits. The drawing below is by the book translator and annotator Donald R. Hill with my captions:
A drawing of the mechanism by Donald Hill with my captions
The candle is placed on a holder inside a brass sheath, and only the wick protrudes through a hole in the cap. A long rod is soldered to the bottom of the holder. The rod runs through the main weight so that the weight is free to move up and down. Two strings are connected to the bottom of the rod and through two pulleys to the main weight. The latter is relatively heavy, slightly more than one kilogram. At nightfall the wick is lit, at that time the candle is in full size, the rod reaches its lowest point and the main weight its highest. As the candle is consumed, the main weight will descend exerting force, through the pulleys, on the holder upward and the holder and rod will go up at a constant rate depending on the rate of the combustion. A string which turns the scribe is attached to the bottom of the weight. Every hour the scribe and his pen will cover 150, so one can tell the time within 4 minutes. The holder pulls the ball’s channel up and every hour the highest ball in the channel has risen until it is level with the hole in the back of the falcon’s head, at which point it rolls out and falls from the falcon beak.
Minutes and their measurement
The globe and the clock face owe their divisions to a numerical system which is four thousand years old. The Babylonians made astronomical calculations using Sexagesimal (base 60) numeral system. We can only conjecture why people of the ancient Middle East (Assyrians were also Sexagesimal ) adopted the use of base 60. One assumption is that the number 60 was chosen because it is the first number divisible by all the numbers 1 to 6. Alternatively, base 60 was preferred because the lunar year contains three hundred and sixty days. There are more suggestions. Hipparchus of Nicaea already mentioned here(Hebrew), as well as other Greek astronomers, used the tools previously developed by the Babylonians astronomers. Hipparchus used the geometry of a sphere to find locations on Earth. There were attempts to use grid lines before, but he was the first to apply rigorous mathematical principles to the determination of places on the Earth’s surface, by specifying their longitude and latitude in terms of 3600 running South to North(longitude) and parallel to the equator(latitude).
Claudius Ptolemy considered the most famous astronomer of antiquity. His book the Almagest, from Arabic (المجسطي) is considered to be one of the most influential scientific texts of all time. Its geocentric model whereby planets revolve around Earth was accepted for more than twelve hundred years until the work of Nicolaus Copernicus in the 16th century. Ptolemy used and expanded the work of Hipparchus by subdivisions of 3600 of longitude and latitude into smaller sections. Each degree was divided into sixty parts called “partes minutae primae” literally “the first small part.” This was later reduced to minutes. The minutes were further divided into sixty “partes minutae secundae” or “second small parts.” Later reduced to seconds. Interestingly enough the time units in Hebrew “DAKA” and “SHNIYA” reflect the historical names.
Clock still didn’t show minutes and seconds for hundreds of years after the Almagest, partly because of technology limitations and partly because there was no need. In the middle ages, the meaning of an hour as sixty minutes was not understood by most people. Not many mechanical clocks from the fourteenth century are left, but those I could find do not have hands, in most cases, and ring a bell to indicate the hours.
The Salisbury cathedral clock is said to be the oldest working clock in the world. It is dated to 1386 (not certain). It is a large iron-framed clock without a dial and obviously with no hands. There are other clocks competing for this title. None of them has minutes’ hand:
The Salisbury cathedral clock
The Forchtenberg clock tower in a small town in south Germany is one of the oldest surviving mechanical clock towers. In contrast to the controversial dating of the Salisbury cathedral clock, the year 1463 is carved in iron. The only uncertainty; was the clock made at this date? Or could it be older and this is the first repair date? This clock has only an hour hand:
The Forchtenberg clock tower
Who was the first to install the minute hand? It is not clear, but the second hand has a story we know. Jost Bürgi was a Swiss clockmaker, a maker of astronomical instruments and a mathematician. He was employed at the Court William IV, Landgrave of Hesse-Kassel, a mathematician and astronomer by himself. Although now forgotten he was an outstanding astronomer, his observations, particularly those of the fixed stars, were at least as accurate as those by Tycho Brahe. Bürgi was brought to the court to develop scientific instruments, and assist in the observation that could confirm the heliocentric model by Copernicus. He built various instruments. In 14th April 1586, the count wrote to Tycho Brahe about a highly accurate clock which Bürgi had built which, for the first time, had a minute hand, a seconds hand and had an error of less than a minute in 24 hours! Christoph Rothman, another astronomer wrote about the new amazing clock:
“The duration of a second is not very short but resembles the length of the shortest note in a moderately slow song.“
This quote commemorates a time when science and technology produce a new reality.
Bürgi precision clock
Epilogue
I read today about a new exhibition of Christian Boltanski in the Israel Museum called “life”. He wrote: [my translation from Hebrew]
“a major part of my job is the fact that each person is special, one-of-a-kind and important, each will finally vanish. Most of us will be forgotten in two generations, with the passing of those close to us. “
It’s certainly not true for al-Jazari but probably true for most of us. The exhibition combines early works of Boltanski alongside new works and includes a digital timer continually counting the seconds from the moment of birth of the artist. I found a photo of a timer installation of Boltanski at the Biennale. I don’t know if the installation in the Israel Museum is identical.
Christian Boltanski, the Venice Art Biennale, 2011.